GRATEX

GRATEX I - HSSCo

For taps according to DIN 371 (2 teeth / angle 90°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 90 degrees.

MORE


For taps according to DIN 371 (2 teeth / angle 120°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 120 degrees.

MORE


For taps according to DIN 371 (3 teeth / angle 90°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 90 degrees.

MORE


For taps according to DIN 371 (3 teeth / angle 120°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 120 degrees.

MORE


For taps according to DIN 376 (2 teeth / angle 90°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 90 degrees.

MORE


For taps according to DIN 376 (2 teeth / angle 120°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 120 degrees.

MORE


For taps according to DIN 376 (3 teeth / angle 90°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 90 degrees.

MORE


For taps according to DIN 376 (3 teeth / angle 120°)

For deburring and chamfering of tapped holes if using a tap according to DIN 371 with angles of 120 degrees.

MORE


Setup and working process

Cutting heads for GRATEX I - HSSCo

For taps according to DIN 371 or DIN 376 (2 teeth / angle 90°)

Zur Verwendung im GRATEX I

MORE


For taps according to DIN 371 or DIN 376 (2 teeth / angle 120°)

Zur Verwendung im GRATEX I

MORE


For taps according to DIN 371 or DIN 376 (3 teeth / angle 90°)

Zur Verwendung im GRATEX I

MORE


For taps according to DIN 371 or DIN 376 (3 teeth / angle 120°)

Zur Verwendung im GRATEX I

MORE

GRATEX II - HSSCo

For deburring and chamfering

in combination with spiral drills of type N with an angle of 90 degrees.

MORE


Setup and working process

GRATEX III - HSSE

For deburring and chamfering

in combination with spiral drills of type N with an angle of 90 degrees. The GN-GRATEX III is mounted into the collet together with the drill.

MORE


Setup and working process